Guide to Homebrew Testosterone Cypionate Powder
You may consider buying steroids raw powder and make the finished Testosterone yourself. We will teach you how to make testosterone Cypionate powder.
Each millilitre of 100 mg per ml solution contains:
- 100 mg of Testosterone Cypionate powder
- 1 millilitre of Benzyl benzoate
- 736 mg of Cotton seed oil
- 45 mg of Benzyl alcohol
- A digital scale that can measure 0.01g
- A sterile syringe filter 22um
- Thermometer
- Needles
- Sterile glass Vial that is of any size
- Syringe of any size
The first step is to weigh the needed Testosterone Cypionate and place it into a glass beaker. Add Benzyl Benzoate and Benzyl Alcohol. (Edited by Hongxipharm)
The solvents start dissolving the powder straightaway but if you want to speed up the process, you can use a water bath. Place the vial into a little water in a pan or any other suitable place. Do not use too hot water because some products may oxidise. The carrier oil you intend to use should be of similar temperature as the solution so if you decide to warm the solution then the carrier oil should be warmed too. The reason of doing this is to ensure that all the powder dissolves into the solvents. Ensure that there is no visible powder left behind in the solution.
Take the warmed cotton seed oil into the solution. Mix properly and ensure that there are no hormone swirls and if it happens, take the solution away from the water bath and get it to the filtering process.
The next step is using a syringe to draw up the solutions that you will use to filter with. You can use the large syringe once or a smaller syringe multiple times. Unpack the 0.22 um sterile syringe filter and push the green needle into the lesser side and put on the syringe.
Use an alcohol swab to wipe the upper part of the sterile vial. Insert the green needle in it and place the needle hooked on the syringe filter into the vial.
At times you may find out that the filter may get blocked or the process may slow down. In this case, you can make a replacement of the filter with another one to save time. The type and amount of steroid powder that you use is what determines the amount of time that the process takes.
The product is ready to use after you filter the product in the sterile vial.
Hongxi Pharm Team
All Rights Reserved