How to Mix Trenbolone Acetate Powder

How to Mix Trenbolone Acetate Powder

Tren Acetate powder is famous for being one of the strongest anabolic steroids in the world. It is especially effective in the cases of performance enhancement. What’s more, trenbolone acetate is also one of the most versatile since it works well in bulking and cutting cycles alike.  Many people get raw trenbolone acetate powder from internet, and it is easy to buy trenbolone acetate powder online. But how to mix raw trenbolone acetate powder when buy trenbolone acetate powder online? Here is the recipe for reference. Before you mix raw trenbolone acetate powder(trenbolone acetate homebrew), you must know what is that and what are you doing, and the risk. Do not try trenbolone actate homebrew if you do not know anything about trenbolone acetate.

What are the things you need prepare as bellow:

-Tren Acetate 100mg/ml @500ml

-50g Tren Acetate powder

-10ml BA

-100ml BB

-350ml Grape seed oil

Trenbolone acetate homebrew step by step:

Step 1:

Weigh the steroid powder into the glass beaker as shown above, add the Benzyl Alcohol and Benzyl Benzoate

Step 2:

The solvents will begin immediately dissolving the powder but in order to speed the process up it is possible to use a water bath. Pace the vial into a few cm of water in a pan or something similar: it is important not to use water that is too hot because this will cause some products to oxidize-150f is a good temperature to use, alternatively boiled water from the kettle.

The carrier oil should be the same temperature as the solution when it is added so if you warm the solution in a water bath you should also the same to the carrier oil. The objective at this point is simply to fully dissolved the powder into the solvents. There should be no “Hormone swirls” or any visible powder remaining in the solution and once this is achieved move on to the next step.

Step 3:

Add the warmed grape seed oil to the solution, this case 35ml must be added. Mix thoroughly again, there should be no hormone swirls-once this occurs remove immediately from the water bath and move on to the filtering process.

The steroid powder is fully dissolved in the solvents, the carrier oil is added and the product is ready to be filtered.

Step 4:

Draw up the solutions into the syringe you will be filtering with, this can be a single large syringe or this can be repeated multiple times with a smaller syringe. Remove the 0.22um sterile syringe filter from it’s packing and fix the green needle to the smaller side and then apply to the syringe. (Edited by SARMs Steroid)

Wipe the top of the sterile vial with an Alcohol swab and insert the green needle in it, put the needle attached to the syringe filter into the vial.

Pay attention: The second needle equalizes the pressure as the solution enters the vial. Apply pressure to the syringe plunger to the filter the mixture. This is the most important part of this entire process as it is what sterilizes your product. All finished steroids from any steroid lab must go through this very process.

Occasionally one may find that the filter gets blocked or that the process slows drastically-it is acceptable to replace the filter with a new one if this occurs to save time. The time it takes to filter steroids depends on which steroid is being filtered and how much is being filtere, as well as the mg/ml of the product.

Once the product is filtered in the sterile vial the process is complete.

Hongxi Pharm Team
All Rights Reserved